Xnova Motor 2205-2600kva Hypersonic Multi Rotor Racing Motors
Xnova motors are made from the finest components available today and guaranteed for the highest levels of performance and efficiency. Each Xnova motor is 100% hand wound and guaranteed to perform. Be convinced by the results, not just datasheets.
- High performance and finest CNC quality
- Ultimate efficiency
- Low cogging torque and smooth running
- Precise balancing and fully tested
- 100% handwound
- RPM/Volt: 2570
- No-Load Current: (@10v) 1.6A
- Weight: 30g
- Battery: 3-4s
- Resistance: 0.045ohm
- Prop Shaft Diameter M5
Please Note: High KV motors (2500KV and above) require more care and attention to detail when configuring your ESC's and flight controller.
For optimum timing setting please start with LOW/MED timing and increase the timing until motors run smoothly and show no signs of desync.
We have found LOW/MED timing settings to work well on our 2204 2600kv and 2205 2600kv however may vary on different setups.
PID's should be halved from the standard settings and worked up until optimum tune is achieved.
Operation of motors with PID's too high can cause exponential oscillations which will cause damage the motors and ESC's.
As part of Xnova's stringent quality control procedures, all motors are run before shipping to ensure you receive high quality, fault free motors.
Please take the time to correctly setup your new Xnova motors to get the best performance and ensure trouble free operation.