Description
LOOKING TO BUY A DIATONE MAMBA F722 APP F50PRO 3-6S FLIGHT CONTROLLER STACK IN AUSTRALIA? YOU'VE COME TO THE RIGHT PLACE. ANY QUESTIONS? PLEASE LIVE CHAT US, WE'RE HERE TO HELP!
CHECK OUT OUR GREAT RANGE OF DIATONE PRODUCTS HERE
FIRMWARE TARGET /CONFIG: MAMBA F722 I2C
Please note:Since STM32F722 heat large , please leave at least 5mm interspace at both sides of the FC with nothing covered to make sure a good air circulation.
Update Details:
- BT to WiFi
- USB power supply can use receiver, OSD
- Add a group of I2C pads (SCL SDA)
- Add inverter Dual-Way TX serial port
- Add 2812 LED switch function, key can turn off led
- Add 4 corner LED interface to support BF led and Mamba led
- Upgrade to stronger type-C, optimize pad position
FC Specifications
- MCU: 216MHz STM32F722RET6 32BIT
- IMU: MPU6000
- Barometer: No
- OSD: BF OSD
- Blacbox: 16M Flash Memory
- Uarts: 6Set
- ESC Soft: Dshot300/600/1200
- ESC Telemetry: RX6
- LED indicator: Blue&Orange for FC Status,Green 9V,White 5V,Red 3.3V
- LED Controller:BF LED/MB LED( 4 Set 2812 LED)
- WIFI: SpeedyBee APP
- Smartaudio: Yes
- Buzz: Yes
- Input: 3~6S Lipo (12.6~25V)
- TVS Protection: Yes
- BEC: 5V 2.5A & 9V 2A (Max 3A)
- MOUNTING: 30.5mm/M3 WEIGHT: 9g
- Supply :
- 8pin sh1.0 *1
- Smartaudio: Yes
- Buzz: Yes
- Input: 3~6S Lipo (12.6~25V)
- VTS Protection: Yes
ESC Specifications
F50PRO
- INPUT VOLTAGE: 3~6S Lipo (12.6V~25V)
- CONTINUE CURRENT: 50A×4
- BURST CURRENT: 60A (10S)
- BEC: NO
- ESC Dshot300/600/1200
- MOUNTING: 30.5mm/M3
- Supply : Panasonic High Frequency 470uF/35V
- Mounting: 30.5×30.5mm,Φ3
- Dimensions:
- Weight: 22g
Including
- 1× MAMBA F722 APP <WIFI> F50PRO
Important Notes:
- Before soldering or mounting any flight controller, connect it to your PC and verify operation
- Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
- Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty.
- USB ports must be handled with care, breakage of usb ports are not covered under warranty
- Always use a smoke stopper before powering your build for the first time.
About SpeedyBee Function:
For WIFI
For BlueTooth