DIATONE MAMBA F722 MINI FLIGHT CONTROLLER + 306 4IN1 6S POWER STACK

MB-STACK-F722MINI

  • $139.95

Will be in stock after
Add to Wishlist

DIATONE MAMBA F722 MINI FLIGHT CONTROLLER + 306 4IN1 6S POWER STACK


FC Specifications

  • FIRMWARE TARGET : MAMBA F722 (LEGACY)
  • MCU: 216MHz STM32F722RET6 32BIT
  • IMU: MPU6000
  • Baro: No
  • OSD: BF OSD
  • Blacbox: 16M Flash Memory
  • Uarts: 6Set
  • ESC Soft: Dshot300/600/1200
  • ESC Telemetry: RX2
  • LED: Blue&Orange for FC Status,,White 5V,Red 3.3V
  • WS2812 LED Control: BF LED Control
  • Smartaudio: Yes
  • RSSI: Yes
  • Buzz: Yes
  • Input: 2~6S Lipo (8.4~25V)
  • VTS Protection: Yes
  • BEC: 5V 2A (Max 3A)

ESC Specifications

  • INPUT VOLTAGE: 2~6S Lipo (7.4V~25V
  • CONTINUE CURRENT: 30A×4
  • BURST CURRENT: 35A (10S)
  • BEC: NO SOFT: Dshot300/600/1200
  • MOUNTING: 20mm/M2

Stack Specifications

  • Mounting: 20×20mm,Φ2
  • Dimensions: 30×36.5×13.5mm
  • Weight: 11g

Package Includes

 

  • 1x Diatone Mamba F722 Mini 20x20 Flight Controller
  • 1x Diatone Mamba 306 2-6S 30A 20x20 4in1 ESC
  • 1x Panasonic High-Frequency 470uF/35V Capacitor
  • 1x Protective Top Plate
  • 1x XT60 Connector
  • 2x 4in1 ESC Connector Cable
  • 4x Spare Stack Bolts
  • 12x O-Ring Dampeners

 

Important Notes: 

Because STM32F722 generates a lot of heat, please leave at least 5mm interspace at both sides of the FC with nothing covered to make sure of good air circulation and so that it doesn't overheat and fail.

  • Before soldering or mounting any flight controller, connect it to your PC and verify operation
  • Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
  • Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty. 
  • USB ports must be handled with care, breakage of usb ports are not covered under warranty
  • Always use a smoke stopper before powering your build for the first time. 


We Also Recommend