DIATONE MAMBA F722S FLIGHT CONTROLLERFC-MB-F722S
DIATONE MAMBA F722S FLIGHT CONTROLLER
FIRMWARE TARGET ： MAMBA F722 （LEGACY）
- MCU: 216MHz STM32F722RET6 32BIT
- IMU: MPU6000
- Baro: No
- OSD: BF OSD
- Blacbox: 16M Flash Memory
- Uarts: 6Set
- ESC Soft: Dshot300/600/1200
- ESC Telemetry: RX6
- LED: Blue&Orange for FC Status,,Green 9V,White 5V,Red 3.3V
- Controller: 4 Set 2812 LED
- Bluetooth: SpeedyBee APP
- Smartaudio: Yes
- RSSI: Yes
- Buzz: Yes
- Input: 3~6S Lipo (12.6~25V)
- VTS Protection: Yes
- BEC: 5V 2A & 9V 2A (Max 3A)
- Mounting: 30.5×30.5mm,Φ3
- Weight: 6g
- Target: MAMBA F722
- 1 x DIATONE MAMBA F722S FLIGHT CONTROLLER
Because STM32F722 generates a lot of heat, please leave at least 5mm interspace at both sides of the FC with nothing covered to make sure of good air circulation and so that it doesn't overheat and fail.
- Before soldering or mounting any flight controller, connect it to your PC and verify operation
- Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
- Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty.
- USB ports must be handled with care, breakage of usb ports are not covered under warranty
- Always use a smoke stopper before powering your build for the first time.
We Also Recommend
DIATONE MAMBA F50 Pro 50A 3-6S Dshot1200 4 IN 1 Blheli_32 Brushless ESC
DIATONE MAMBA F405 FLIGHT CONTROLLER + F40 ESC POWER STACK MK2