{"product_id":"holybro-pm07-power-module-14s","title":"Holybro PM07 Power Module (14S)","description":"\u003cdiv id=\"shopify-section-template--16754115969213__sub\" class=\"shopify-section product-full-width\"\u003e\n\u003cdiv class=\"page-width page-width--narrow\"\u003e\n\u003cdiv class=\"product-block\"\u003e\n\u003cdiv class=\"rte\"\u003e\n\u003cp\u003e\u003cspan\u003eThis PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power \u0026amp; signal distribution for up to 8 ESCs.\u003cbr\u003e\u003cbr\u003ePM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.\u003cbr\u003e\u003cbr\u003eIt is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C \u0026amp; Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector. \u003c\/span\u003e\u003c\/p\u003e\n\u003ch3\u003e\u003cspan\u003e\u003cstrong\u003eSpecifications：\u003c\/strong\u003e\u003c\/span\u003e\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eInput voltage: 2S-14S\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003ePCB Cont. Current Rating: 90A\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003ePCB Burst Current Rating: 140A (\u0026lt;60 Sec)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eOutput: DC 5.2V \u0026amp; 3A Max \u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eVoltage Divider: 18.182\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eAmperes per Volt: 36.364 \u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cspan\u003e\u003cstrong\u003ePlease Note: \u003c\/strong\u003e\u003cbr\u003e\u003c\/span\u003e\u003c\/p\u003e\n\u003col\u003e\n\u003cli\u003eThe PM07 12S version has been discontinued and replaced by the 14S version. \u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eThe XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (\u0026lt; 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to \u003ca href=\"https:\/\/docs.holybro.com\/power-module-and-pdb\/power-module\/connector-and-wire-rating\" aco-visited=\"true\"\u003ethis chart \u003c\/a\u003efor reference. \u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eThis PM07 Power Module uses analog data output and is not compatible to the Pixhawk 5X \u0026amp; 6X (Requires a digital PM like PM02D). \u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003cp\u003e\u003cspan\u003e\u003cstrong\u003eMechanical Specification:\u003c\/strong\u003e\u003c\/span\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eDimensions:68*50*10 mm\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eMounting Holes:45*45mm\u003c\/span\u003e\u003c\/li\u003e\n\u003cli align=\"left\"\u003e\u003cspan\u003eWeight: 43.8g\u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cspan\u003e\u003cb\u003eSetup guide for PX4 \u0026amp; Ardupilot can be found in the \u003ca href=\"https:\/\/docs.holybro.com\/power-module-and-pdb\/power-module\" aco-visited=\"true\"\u003eHolybro Doc here.\u003c\/a\u003e\u003cbr\u003ePM07 User guide can be \u003ca href=\"https:\/\/docs.holybro.com\/power-module-and-pdb\/power-module\/pm07-quick-start-guide\" aco-visited=\"true\"\u003efound here\u003c\/a\u003e\u003c\/b\u003e\u003c\/span\u003e\u003c\/p\u003e\n\u003ch3\u003e\u003cspan\u003e\u003cstrong\u003ePackage Include:\u003c\/strong\u003e\u003c\/span\u003e\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003e\u003cspan\u003e1x   PM07 board\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003e1x   80mm XT60 connector wire (installed)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003e1x   Electrolytic capacitor: 220uF 63V (installed)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003e2x   JST GH 10P Cable\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003e1x   JST GH 8P Cable\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003e2x   JST GH 6P Cable\u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003cdiv id=\"shopify-section-template--16754115969213__collection-return\" class=\"shopify-section\"\u003e\n\u003cdiv class=\"text-center page-content page-content--bottom\"\u003e\n\u003ca href=\"https:\/\/holybro.com\/collections\/power-modules-pdbs\" class=\"btn btn--small return-link\" aco-visited=\"true\"\u003e\u003c\/a\u003e\u003cbr\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003cdiv id=\"shopify-section-template--16754115969213__product-recommendations\" class=\"shopify-section\"\u003e\n\u003cdiv id=\"Recommendations-template--16754115969213__product-recommendations\" data-section-id=\"template--16754115969213__product-recommendations\" data-section-type=\"product-recommendations\" data-enable=\"true\" data-product-id=\"7150469939389\" data-url=\"\/recommendations\/products?section_id=template--16754115969213__product-recommendations\u0026amp;product_id=7150469939389\u0026amp;limit=5\" data-limit=\"5\" data-preorder-id=\"7150469939389\" d-id=\"7150469939389\"\u003e\n\u003cdiv data-section-id=\"7150469939389\" data-subsection=\"\" data-section-type=\"collection-grid\" class=\"index-section\"\u003e\n\u003cdiv class=\"page-width\"\u003e\u003c\/div\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e","brand":"Hollybro","offers":[{"title":"Default Title","offer_id":44858288701510,"sku":"15008","price":74.95,"currency_code":"AUD","in_stock":false}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0412\/2761\/files\/15008v24_2_1800x1800_e7010154-9f4a-448c-85bc-abd746e4b4c8.png?v=1775785447","url":"https:\/\/www.nextfpv.com.au\/products\/holybro-pm07-power-module-14s","provider":"Next FPV","version":"1.0","type":"link"}