Holybro Shuriken 180 ARF with FrSky Rx
The Shuriken 180 is an Almost Ready to Fly (ARF) quad from Holybro. Available with built in FrSky S bus receiver, Futaba (FASST) or Spektrum (DSXM). Just bind your radio, configure your switches in cleanflight, strap a battery on and go!
Pre-Tuned out of the box and ready for serious action. This Quad is seriously tough and will suit those starting out and serious racers alike due to its tough design and ability to take hard hits - did someone say carpark racer?
The sturdy 180mm frame is composed of injection molded plastic bumper sandwiched between carbon fiber top and fiberglass reinforced bottom. Coupled with impact resistant motors, sturdy antenna, and plastic skid protection, the Shuriken 180 is a great place to start whether you are just getting into flying or starting to get serious about freestyle and racing. For racing veterans its the perfect pull out, beat up quad that doesn't require hours of wrench time.
With built in F3 flight controller, 5.8ghz 25mw push button transmitter, smart carry case and built in receiver its a no brainer!
This version ships with a FrSky S bus receiver (XJT/Taranis compatible), we also stock Futaba (FASST) and Spektrum (DSMX) versions.
NEW! Download STL 3D print files and colour customise your Shuriken 180!
- There is currently no requirement to update the firmware on the Shuriken - if you decide to upgrade the firmware please proceed with caution, take note of all settings prior and remove props before attempting any upgrades or testing of control and fail-safe.
- FrSKY DJT series module is not compatible with the included XSR receiver
- Race32 F3 32-bit Flight Controller with Independent Anti-vibration IMU
- 5.8GHz, 25mw Vtx with built in push button switching and channel display
- Integrated PDB with Fiberglass-reinforced Heatsink Bottom Plate
- OneShot125 20A / 30A burst ESC's
- 1806-2700kv, Large-shaft Motors
- PAL/NTSC switchable. 800 TVL CMOS Camera
- 3K Single-weave Carbon Fiber Top Plate with Injection-molded Heavy-duty Plastic Skirt and Skid Protection
- Futaba and FrSky S.bus, Spektrum DSMX, or PPM Compatible, Receivers available
- 180mm, 4" props , 240g
- CleanFlight Pre-loaded | BetaFlight Ready
- 1 x Shuriken 180 with FrSKY XSR receiver built in
- 1 x Molded soft shell carry case
- 2 x Sets of 4x4 Tri-blade props
- 1 x Circular polarised antenna
- 1 x Battery strap
- 1 x Instruction manual
- 3 or 4 cell 1000 - 1300mah Lipo battery
- 2.4ghz Radio (FrSKY/Futaba Fasst/Spektrum DSMX)
- Cleanflight installed on your pc or mac for config of switches
- 5.8ghz equipped FPV goggles (for FPV flight) Available Here