MATEK F405 CTR AIO FLIGHT CONTROLLER

MATF405CTR

  • $56.95
  • Save $3.05

Will be in stock after
Add to Wishlist

Matek has been a market leader in low cost, high-quality components, always pushing the boundaries of what a good FC or PDB can be. This product combines the two with the reliable MPU6000 gyro, soft mount grommets and a powerful F405 MCU. THE FC is fully featured including OSD and SD Card Slot.

We chose this board because of it's performance, as well as the fact that a lot of our frames rely on a common hole mounting for FC and arms. We didn't want people limited in the use of metal bolts in order to obtain soft mounting.

FC Specifications
  • MCU: 168MHz STM32F405
  • IMU: MPU6000 accelerometer/gyro (SPI)
  • Baro: BMP280 (I2C)
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • VCP, UART1, UART2, UART3, UART4, UART5
  • Built in inverter for SBUS input (UART2-RX)
  • PPM/UART Shared: UART2-RX
  • SoftSerial on TX2, S5 or S6 optional
  • Camera control on S6 or DAC optional
  • Smartaudio & Tramp VTX protocol supported
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes
PDB Specifications
  • Input: 6~30V (3~6S LiPo) w/TVS protection
  • PDB: 4x30A (Max.4x46A), 6 layers*2oz copper PCB
  • BEC: 5V 2A cont. (Max.3A)
  • LDO 3.3V: Max.300mA for Spektrum RX
  • Current Sensor 184A (Scale 179)
  • Battery Voltage Sensor: 1:10 (Scale 110)
  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • 6x PWM / DShot outputs without conflict
  • 5x UARTs
  • 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
  • 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  • 1x pair I2C1 pads
  • 1x Side-press button for BOOT(DFU) mode
  • 36x46mm PCB with 30.5mm mounting holes
  • 10g
  • w/ 1x Rubycon ZLH 35V/470uF (Low ESR)
  • w/ 6x silicon grommets M4 to M3
  • w/ 1x FR4 PCB Plate 36*36*1mm

Important Notes: 

  • Before soldering or mounting any flight controller, connect it to your PC and verify operation
  • Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
  • Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty. 
  • USB ports must be handled with care, breakage of usb ports are not covered under warranty
  • Always use a smoke stopper before powering your build for the first time. 

Customer Reviews

Based on 6 reviews Write a review

We Also Recommend