MATEK F405-WING FLIGHT CONTROLLER

F405-WING

  • $71.95

Will be in stock after
Add to Wishlist

Matek's F405-Wing is the premier flight controller made specifically for FPV wing aircraft. Loaded with an array of features and tons of room for peripherals, this board lets you choose how you want to fly. INAV OSD, Blackbox, VCP and 6 UARTS, room for 2 motors and 7 servo outputs, 4 BEC and more. It might be easier just to read the spec sheet.

Specifications

  • MCU: 168MHz STM32F405
  • IMU: MPU6000 accelerometer/gyro (SPI)
  • Baro: BMP280 (I2C)
  • OSD: INAV OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • VCP & 6x UARTs
  • 2x Motors, 7x Servos outputs
  • 2x I2C
  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • Built ininverter for SBUS input (UART2-RX)
  • PPM/UART Shared: UART2-RX
  • SoftSerial on TX2 pad
  • Battery Voltage Sensor: 1:10 (Scale 1100)
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes


FC Firmware

  • INAV Flight
  • Target: MATEKF405SE

PDB

  • Input voltage range: 9~30V (3~6S LiPo) w/TVS protection
  • 2x ESC power pads
  • Current Senor: 104A, 3.3V ADC, Scale 317

BEC 5V output

  • Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
  • Continuous current: 2 Amps, Max.3A

BEC 9V /12V output

  • Designed for Video Transmitter, Camera, Gimbal ect.
  • Continuous current: 2 Amps, Max.3A
  • 12V option with Jumper pad

BEC Vx output

  • Designed for Servos
  • Voltage adjustable, 5V Default, 6V or 7.2V via jumper
  • Continuous current: 5 Amps, Max.6A
  • Output Ripple: 50mV (VIn=24V, VOut=5V@5A load)

BEC 3.3V output

  • Designed for Baro / Compass module and Spektrum RX
  • Linear Regulator
  • Continuous current: 500mA

Physical

  • Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
  • Dimensions: 56 x 36 x 13 mm
  • Weight: 25g

Includes

  • 1x Matek 405-Wing FC
  • 3x Pin Headers

Important Notes: 

  • Before soldering or mounting any flight controller, connect it to your PC and verify operation
  • Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
  • Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty. 
  • USB ports must be handled with care, breakage of usb ports are not covered under warranty
  • Always use a smoke stopper before powering your build for the first time. 

Customer Reviews

Based on 2 reviews Write a review

We Also Recommend