MATEK F411-MINI SE FLIGHT CONTROLLER

F411-MINISE

  • $36.95

Only 3 left!
Add to Wishlist

The Matek F411-Mini SE Flight Controller is an F4 FC with built-in Baro, BEC 5V/2A, MPU6000, OSD and supports PDB, INAV and many other cool features!



FC Specifications

  • MCU: 100MHz STM32F411CEU6
  • IMU: MPU6000 (SPI)
  • Baro: BMP280 (I2C)
  • OSD: AT7456E (SPI)
  • Blackbox: No
  • 2x Uarts
  • 2x Softserial-Tx
  • 6x PWM outputs (Dshot/Proshot/oneshot/multishot)
  • 1x I2C
  • 3x ADC (VBAT, Current, RSSI)
  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • 1x SH1.0_8pin connector (Vbat/G/Curr/R6/S1/S2/S3/S4)
  • TR/SA VTX control: Yes
  • Camera control: Yes
  • WS2812 Led control : Yes
  • Beeper output: Yes
  • RSSI: Yes
  • Filtered Vbat output power for VTX, Switchable via AUX (modes tab-user1)
  • Convertible 20mm to 30.5mm mounting
Power
  • Input: 6~36V (2~8S LiPo)
  • BEC: 5V 2A cont. (Max.3A)
  • LDO 3.3V: Max.200mA
  • Battery Voltage Sensor: 1:10 (Scale 110)
  • No Current Sensor built-in, supports external current sensor of PDB/4in1
FC Firmware
  • INAV Target: MATEKF411SE
  • BF unified Target: MATEKF411SE(MTKS)
Physical
  • Mounting
  • 20 x 20mm/Φ3mm with Silicon Grommets
  • 20 x 20mm/Φ2mm with Silicon & Brass Grommets
  • 30.5 x 30.5mm/Φ3mm with Conversion Plate and Silicon Grommets
  • Dimensions: 28 x 28 mm
  • Weight: 5g
Includes
  • 1x F411-miniSE
  • 1x 20mm to 30.5mm conversion plate
  • 6x Silicon grommets M4 to M3
  • 6x Brass grommets M3 to M2
  • 1x SH1.0_8pin cable 5cm
  • 2x SH1.0_8pin connectors

F411-miniSE Quick Start Guide

 

Important Notes: 

  • Before soldering or mounting any flight controller, connect it to your PC and verify operation
  • Incorrect soldering techniques will damage this board and void warranty. Please use the correct sized tip, temperature and technique. Temp controlled soldering irons (such as the TS100) are available for under $100 and will make soldering much easier.
  • Lifted pads are a result of incorrect soldering techniques or excess mechanical pressure and will not be covered under warranty. 
  • USB ports must be handled with care, breakage of usb ports are not covered under warranty
  • Always use a smoke stopper before powering your build for the first time. 

We Also Recommend