Tattu 12000mAh 6S 22.2V 30C UAV lipo battery has stable automatic stacking technology, high capacity than comparable size pack and no memory effect. It is a nice compact little battery, with excellent build and assembly quality. This 12000mAh battery is designed for multicopter usage with long flight time. High power density technology of these batteries ensure all 12000mAh is packed in a small size body, making the total weight is only 1532g. Low IR value of these batteries also provides stable voltage until the end of your mission.
NOTE: Please do not choose expedited shipping unless you live in greater Sydney as batteries cannot be shipped by Air.
- Stable automatic stacking technology makes the single cell capacity can reach 12000mAh
- The most strict single cell capacity, voltage, resistance, discharge curve matching process
- No memory effect
- Minimum Capacity: 12000mAh
- Configuration: 6S1P / 22.2V / 6 cells
- Discharge Rate: 30C
- Max Burst discharge Rate: 30C
- Net Weight(±20g): 1544g
- Dimensions: 192*72*54mm
- Discharge Connector Type:XT90-S
- Balancer Connector Type:JST-XHR
Tattu 12000mAh 6S1P 30C lipo battery is suited to the following models: DJI S800, DJI S900, DJI S1000, Walkera QR X800 and other multicopter.
Lipo Battery Safety
- Batteries should NEVER be left unattended while charging.
- Be absolutely sure that the Lithium Polymer charger settings are correct for the battery pack being charged – both voltage and current settings.
- Lithium Polymer must be CHARGED and STORED in a fire-safe container like a Lipo Sack.
- Do not charge batteries near flammable items or liquids.
- Keep a dry fire extinguisher nearby or a large bucket of dry sand, which is a cheap and effective extinguisher.
- Never charge inside an automobile even when parked.
- KEEP BATTERIES AWAY from children and pets at ALL times.
- Never discharge below 3.5V per cell as it may cause permanent damage and void warranty
- Battery may explode if damaged or disposed of in fire
- Never leave batteries inside a car on a hot day or any other place where temperature may exceed 140F / 60C.
- Although environmentally friendly, lithium polymer cells must be FULLY discharged before disposal. Use a resistor setup (light bulbs, for example) to accomplish this, to avoid the possibility of a short-induced fire after disposal.
- Immediately discharge damaged batteries at 1/2 C rate and dispose
- Do not put the loose cells in a pocket, bag, or drawer where they could short-circuit against other items, or the battery tabs could be pressed against each other.
- Take care that the cells are not punctured, especially by metallic objects like hobby knives.
- If the electrolyte in the cells should get on your skin, thoroughly wash with soap and water. If in the eyes, rinse thoroughly with cool water. Immediately seek medical attention for this, or for burns.